Detection; Signals Detected; Audio Alerts; Visual Display - Cobra 14 BAND XRS 9470 Operating Instructions Manual

Settings and Detection
Your Detector
Pop Alert
(continued)
To Turn Pop Alert On and Off
While no signal is
being detected,
press and hold both
the Dim and City
buttons for four
seconds.

Detection

The tables on the following pages show you the types of Signals your detector
will detect, as well as the voice and visual alerts it provides for each of them.
In Voice Alert mode you will first hear several tones, then a voice message
announcing the type of signal detected, followed by more tones. In Tone Alert
mode, you will hear the tones only.
In both Voice Alert and Tone Alert modes, a distinctly different alert tone is
used for each type of signal detected (including separate tones for each laser
signal). For X, K, Ka and Ku band radar signals, the tones will repeat faster as
you approach the signal source. The repeat rate of the tones gives you useful
information about the signal detected. (See responding to alerts on page 18.)
An indication of the type of signal detected will appear in the UltraBright
data Display. During X, K, Ka and Ku alerts, a number will also appear,
indicating the strength of the signal detected. (1 = weakest, 5 = strongest)
X Signal Detected
2
X K Ka V S
Tone
Pop On = Two beeps
Pop Off = One beep
K Signal Detected
3
X K Ka V S
Voice
Pop On
Pop Off
Ka Signal Detected
5
X K Ka V S
Nothing Comes Close to a Cobra

Visual Display

P will blink twice
in the display
P will blink once
in the display
Ku Signal Detected
4
X K Ka V S
® 15