Table of Contents
Advertisement
5. Adjustment for White Balance
a. Display SMPTE at SXGA/60Hz(Input level 0.73V).
b. Set up [SERVICE MODE].
c. Click "CLEAR EEPROM" and AC Power off.
d. Set up [SERVICE MODE] of the monitor again.
e. Click "WHITE BALANCE" and then select "AUTO".
f. Prepare timing and full black pattern.
g. Click "OFFSET CALIBRATION".
h. After offset calibration is completed prepare full white pattern. i. Click " GAIN CALIBRATION".
6. 9300K color adjustment
a. Select "9300K" in "COLOR TEMP" and enter.
b. Use a 100% IRE white video field in the primary mode.
c. Adjust "CONTRAST " to secure the color temperature.
d. Press "MENU" key to exit adjust mode.
7. 6500K color adjustment
a. Select "6500K" in "COLOR TEMP" and enter.
b. Repeat the adjustment procedure as steps b to d at 9300K.
8. SRGB color adjustment
a. Select "SRGB" in "COLOR TEMP" and enter.
b. Repeat the adjustment procedure as steps b to d at 9300K.
3.5 Service OSD
To enter service OSD menu.
1). Turn off the power switch button.
2). Press volume down,and then power key.
3). Shows the service OSD menu. That menu is located in down side of main menu.
4). The service OSD menu contains additional menus as described below.
a). ADC CALBRATION : Adjust the offset voltage and gain value in PC mode.
b). VIDEO CALBRATION : Adjust the offset voltage and gain value in video input.
c). COLOR TEMP : Adjust R/G/B Color values of contrast and brightness in 9300k, 6500k,User color
d). AGING : Select aging mode. (on/off)
e). CLEAR ETI : Initilize the used time of MFT
f). CLEAR EEPROM : Initilize the EDID DATA at DDC2B EEPROM is saved system memory.
g). DEFAULT TIMING 1 : Select the resolution timing of the signal.
h). DEFAULT TIMIN G2 : Select the resolution timing of the signal.
mode.
Process : Press ok button, and then power key.
Menu is 1152 X 864(VESA standard timing) 1152 x 870 (MAC computer timing).
Menu is 1080 i (video timing) and 1035i.
21
S75F Sony
Advertisement
Table of Contents
