General Cutting Operations - Delta ShopMaster MS250 Instruction Manual

Fig. 33A
GENERAL CUTTING
OPERATIONS
1. Your machine has the capacity to cut standard 2 x 4's
lying flat or on edge, at the 45 degree right and left miter
angles (Fig. 33A).
2. A standard 2 x 6 can be cut in the 90 degree straight
cut-off position in one pass (Fig. 33C) or at 45 degree
right or left miter angles (Fig. 33C).
3. Cutting a standard 4 x 4 can be accomplished with
one pass (Fig. 33D).
4. This machine has the capacity to accurately cut
crown moldings and other bevel-type cuts (Fig. 33E).
4. Cutting various sizes of plastic pipe is an easy job
with this machine (Fig. 33F).
Fig. 33E
16
Fig. 33B
Fig. 33C
Fig. 33D
Fig. 33F