INSTALLATION MANUAL GPS NAVIGATION SYSTEM KNA-G421 B54-4617-08 Warning Failure to avoid the following potentially hazardous situations could result in serious injury or fire. • Do not attempt to install or service the KNA-G421 by yourself. Installing or servicing the unit without training and experience in electronic equipment and automotive accessories may be dangerous and could expose you to the risk of electric shock or other hazards. • When extending ignition, battery, or ground wires, use automotive-grade wires or other wires with AWG 18 (0.75 mm gauge) or greater to prevent wire deterioration and damage to the wire coating. • If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer. • Keep small articles (like screws or batteries) out of the reach of children. If any such object is accidentally swallowed, consult a doctor immediately. Caution Failure to avoid the following potentially hazardous situations may result in injury or property damage.
What’s Included GPS antenna and main unit screws (4) wiring harness hook and loop metal plate fasteners (2) Installing the Main Unit Use the screws or the hook and loop fasteners provided to mount the main unit in the vehicle. Select a location that allows you to access the unit’s SD card slot. Be sure to place the unit horizontally (flat) and secure it completely for best performance. Caution • Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, dust, spills, or liquids. Use only the screws provided. If you use the wrong screws, you could damage the unit.
Page 3
You can bend the metal plate to conform to a curved surface, if necessary. 4. Place the GPS antenna on top of the metal plate. Steps to Install the KNA-G421 WARNING To display unit (NAV I/F terminal) 1. Remove the key from the vehicle’s ignition Do not connect the yellow wire and disconnect the negative battery cable.
Acquiring GPS Signals The first time you turn on the KNA-G421, you must wait while the system acquires satellite signals for the first time. This process could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest acquisition. After the system acquires satellites for the first time, it will acquire satellites quickly each time thereafter.