Invacare TRACER EX2 User Manual page 53


1
A 1 / to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times.
2
5. If the distance between the bottom of anti-tipper wheels and the ground/floor is not 1
Anti-Tippers on page 53.
Adjusting the Anti-Tippers

1
A 1 / to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times.
2
1. Place the wheelchair on a flat surface.
 If adjusting anti-tippers on recliner models, ensure back
canes are in the upright position before making
adjustments.
2. Press the release buttons on the wheeled portion of the anti-tipper
and slide it up or down to the desired adjustment hole.
3. Check to make sure that the release buttons are fully engaged in
adjustment holes.
4. Ensure both anti-tippers are adjusted to the same height.
5. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
6. If the distance between the bottom of anti-tipper wheels and the
1
ground/floor is not 1 /
2
1
distance is 1 / to 2 inches.
2
1
7. If the 1 / to 2 inch distance cannot be achieved, a different model
2
may be required. Contact an Invacare dealer or qualified technician.
Part No 1110546
to 2 inches, repeat steps 2-5 until the
10 ANTI-TIPPERS/WHEEL LOCKS
1
/ to 2 inches, adjust anti-tippers. Refer to Adjusting the
2
FIGURE 3
53
Release Buttons
1
1 / to 2 inch Clearance
2
Adjusting the Anti-Tippers
®
Invacare Tracer™ EX2 Wheelchair