Invacare TRACER EX2 User Manual page 52

10 ANTI-TIPPERS/WHEEL LOCKS
Installing Anti-Tippers
 To ensure the correct model anti-tipper is used refer to chart below. Measurements for anti-tippers are approximate and are taken with
extension tube in bottom hole position.
WHEELCHAIR MODEL
TRACER EX2
TRACER EX2 FF
Anti-Tipper Height
1. Press the release buttons and insert the anti-tippers with the anti-
tipper wheels pointing toward the ground/floor into the wheelchair
frame tubing.
2. Ensure that the release button of the anti-tipper fully protrudes out
of the hole in the bottom of the wheelchair frame tubing.
3. Place the wheelchair on a flat surface.
4. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
®
Invacare Tracer™ EX2 Wheelchair
SEAT-TO-FLOOR
HEIGHT IN INCHES
17½ to 19½
21
Anti-Tipper Length
FIGURE 1 Installing Anti-Tippers - Anti-Tipper Length
ANTI-TIPPER (MEASUREMENTS IN INCHES)
LENGTH HEIGHT
13½
12
Flat Surface
Anti-Tipper
Wheels
Anti-Tipper
Release Buttons
FIGURE 2
52
MODEL
3¼ 1360
2¾ 9758
Bottom Position
Anti-Rattle
Rear Frame Tubing
Installing Anti-Tippers
Part No 1110546
PART NO.
1058836
1086190