Intercom Operation; Handset To Handset Intercom Call - GE 28041 User Manual

If handset 1 is the room monitoring initiator, the following displays will be shown
during the room monitor:
ROOM MONITOR
HANDSET 1
HANDSET 2
Originating Handset
NOTE:
1) If handsets have been named, then the name will be displayed on
the LCD instead of handset numbers.
2) During the room monitoring, it will emit a beep tone if there
are incoming calls. You may press the TALK/CALL BACK button
or SPEAKER button to answer the call and quit the room monitor
mode.
3) While in room monitoring mode, the initiating handset can listen
with the handset speakerphone by pressing the SPEAKER button
once. Switch back to the earpiece by pressing TALK/CALL BACK
button once. Press the *EXIT button to end room monitoring.

Intercom Operation

The intercom feature allows you to have a conversation with another registered
handset without tying up the telephone line, allowing you to still receive incoming
calls.
IMPORTANT NOTE: The following procedures can ONLY be done with
Model 28011 and 28041 handsets.

Handset to Handset Intercom Call

1. Make sure the originating phone is OFF (not in talk mode).
. Press the MENU button and use the 6 or 5 button to scroll to INTERCOM.
. Press the SELECT button to enter the menu.
NOTE: You can press the INT button to shortcut to the menu.
4. A list of registered handsets shows on the display. Use the 6 or 5 button to scroll
to the desired handset you want to page.
4
ROOM MONITOR
FROM
HANDSET 2
HANDSET 1
Receiving Handset