Procedure 1 General Guidelines; Stability - Invacare Spyder 1097049 Operator And Maintenance Manual

PROCEDURE 1
This Procedure includes the following:

Stability

Operating Information
G
Tire Pressure
U
G
Weight Training
I
E
D
Weight Limitation
N
E
Safety/Handling of Wheelchairs
E
L
R
I
A STABILITY
N
L
E
S
The seat dump, back angle, seating system, caster size and position, rear wheel size
and position, anti-tippers, as well as the user condition directly relate to the stability of
the wheelchair. Any change to one (1) or any combination of the nine (9) may cause
the wheelchair to decrease in stability. These adjustments MUST be performed by a
qualified technician ONLY.
To maintain maximum stability, position the rear wheels in the most rearward position in
the axle mounting plate. Moving the rear wheels to any of the other mounting positions
causes the wheelchair to decrease in stability.
ALWAYS ensure stability BEFORE moving the rear wheels forward. TEST wheelchair BE-
FORE it is occupied by the end user to ensure safety.
STABILITY WARNINGS
Seat Dump
Back Angle
Seating System
Caster Size
Caster Position
Rear Wheel Size
Rear Wheel Position
User Condition
NOTE: When changes to the left hand column occur, follow across
the chart and refer to the
safety and handling of the wheelchair.
NOTE: Additional adjustments may be needed according to the wheel-
chair type. Refer to the wheelchair owner's manual for these procedures.
procedure to maintain the proper stability,
6
GENERAL GUIDELINES