Invacare 1080556 Owner's Operator And Maintenance Manual page 63

RECLINER BACK OPTION
DO NOT over tighten the adjusting nut on the recliner cable. Overtightening the
adjusting nut on the recliner cable WILL actuate the gas cylinder, possibly causing injury.
A. CLOCKWISE - Turning the cable adjusting nut clockwise will tighten the recliner
cable. DO NOT overtighten the cable adjusting nut. Turn the cable adjusting nut
clockwise until actuator looks like DETAIL "B".
B. COUNTERCLOCKWISE - Turning the cable adjusting nut counterclockwise will
loosen the recliner cable.
NOTE: If the recliner cable is too loose, the gas cylinders will not work.
C. While holding the cable adjusting nut in place, tighten the cable locking nut against the
cable adjusting nut.
D. Repeat STEP 1.
E. Repeat STEP 2 until the LEFT side of the back DOES NOT recline.
3. Squeeze the trigger release lever of the RIGHT recliner cable assembly and try to recline
the back. The back should not recline.
4. To adjust the RIGHT gas cylinder:
Repeat STEPS 1-3 for the LEFT handle of the recliner cable.
Trigger
Release
Lever
Cable Locking
Nut
Cable Adjusting
Nut
FIGURE 5 - PERFORMING ADJUSTMENTS
Part No. 1080556 Rev. I
WARNING
DETAIL "B"
MUST
TOO
LOOK
LOW
LIKE THIS
Actuator
Housing
63
PROCEDURE 10
TOO
HIGH
Actuator
Solara™