Table of Contents
Advertisement
Altering an option or a running programme
It is possible to change some options before the pro-
gramme carries them out.
Before you make any change, you must PAUSE the ap-
pliance by pressing the button 6 .
Changing a running programme is possible only by re-
setting it. Turn the programme selector dial to Off and
then to the new programme position. Start the new pro-
gramme by pressing the button 6 again. The washing
water in the tub will be not emptied out.
Interrupting a programme
Press the button 6 to interrupt a programme which is
running, the corresponding green pilot light starts blink-
ing.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to Off position to cancel a pro-
gramme which is running. Now you can select a new pro-
gramme.
Opening the door
After the programme has started the door is locked. If,
for any reason, you need to open it, set firstly the ma-
chine to PAUSE by pressing the button 6 . After a few
minutes the pilot light 8.2 goes off and the door can be
opened.
If the door remains locked, this means that the machine
is already heating or that the water level is too high. In
any case, do not try to force the door open!
If you cannot open the door but you need to open it you
have to switch the machine off by turning the selector
Stand by : once the programme has finished after a few
minutes the energy saving system will be enabled. The
brightness of the display is reduced. By pressing any
Helpful hints and tips
Sorting out the laundry
Follow the wash code symbols on each garment label
and the manufacturer's washing instructions. Sort the
laundry as follows: whites, coloureds, synthetics, deli-
cates, woollens.
Before loading the laundry
Never wash whites and coloureds together. Whites may
lose their «whiteness» in the wash.
dial to Off position. After a few minutes the door can be
opened (pay attention to the water level and tempera-
ture!) .
After closing the door, it is necessary to select the pro-
gramme and options again and to press button 6 .
At the end of the programme
The machine stops automatically. The three blinking ze-
ros (
) appear on the display, the pilot light of
button 6 goes off and after a few minutes the 8.2 pilot
light goes off. The light 8.3 illuminates and some acous-
tic signals sound. The door can be opened.
If a programme or an option that ends with water left in
the tub has been selected, the light 8.2 illuminates and
the door remains locked to indicate that the water must
be emptied out before opening the door.
Follow the below instructions to empty out the water:
1. Turn the programme selector dial to Off .
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the
relevant button.
4. Press button 6 .
At the end of the programme, the door can be now
opened. Turn the programme selector dial to Off to
switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open
to prevent the formation of mildew and unpleasant smells.
button the appliance will come out of the energy saving
status.
New coloured items may run in the first wash; they
should therefore be washed separately the first time.
Button up pillowcases, close zip fasteners, hooks and
poppers. Tie any belts or long tapes.
Remove persistent stains before washing.
Rub particularly soiled areas with a special detergent or
detergent paste.
Treat curtains with special care. Remove hooks or tie
them up in a bag or net.
9
Advertisement
Table of Contents
