Table of Contents
Advertisement
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
partment if the selected programme/option it requires
(see more details in "Detergent dispenser drawer").
If required, pour fabric softener into the compartment
marked
(the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by turning the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme. The green pilot light of the button 6 starts to
flash.
The selector dial can be turned either clockwise or coun-
terclockwise. Turn to position « Off » to reset pro-
gramme/ switch the machine off.
At the end of the programme the selector dial must be
turned to position «Off» , to switch the machine off.
Caution! If you turn the programme selector dial
to another programme when the machine is
working, the red pilot light of button 6 will blink 3
times to indicate a wrong selection. The machine will
not perform the new selected programme.
Select the spin speed, the Night Cycle or the
Rinse Hold option by pressing button 2
The washing machine will automatically select the max-
imum spin value provided for the programme you have
chosen. (See "Washing programmes" for the maximum
allowed spin speed).
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a different speed.
The relevant light will light up.
Select the available options by means of buttons 3
and 4
Depending on the programme, different options can be
combined. These must be selected after choosing the de-
sired programme and before starting the programme.
When these buttons are pressed, the corresponding pi-
lot lights illuminate. When they are pressed again, the
pilot lights go out. If an incorrect option is selected, the
integrated red pilot light of the button 6 flashes 3 times
and the message Err is displayed.
For the compatibility among the washing programmes
and the options see chapter «Washing programmes» .
8
or in the appropriate com-
Select the Delay Start by pressing button 7
Before you start the programme, if you wish to delay the
start, press this button to select the desired delay.
The selected delay time value will appear on the display
for a few seconds, then the duration of the programme
will appear again.
You must select this option after you have set the pro-
gramme and before you start the programme.
You can cancel or modify the delay time at any moment,
before you press button 6 .
Selecting the Delay Start:
1. Select the programme and the required options.
2. Select the delay start by pressing button 7 .
3. Press button 6 :
- the machine starts its hourly countdown.
- the programme will start after the selected delay
has expired.
Cancelling the Delay Start after having started the pro-
gramme:
1. Set the washing machine to PAUSE by pressing but-
ton 6 .
2. Press button 7 once until symbol
the display.
3. Press button 6 again to start the programme.
Important!
• The selected delay can be changed only after select-
ing the washing programme again.
• The door will be locked throughout the delay time. If
you need to open the door, you must first set the wash-
ing machine to PAUSE by pressing button 6 and wait
a few minutes before opening the door. After you
have closed the door, press the same button again.
Important! The Delay Start cannot be selected with
DRAIN programme.
Start the programme by pressing button 6
To start the selected programme, press this button; the
corresponding green pilot light stops blinking.
The pilot light Wash ( 8.1 ) and Door ( 8.2 ) illuminate
to indicate that the appliance starts operating and the
door is locked.
If you have chosen a delayed start, the machine will be-
gin the countdown.
Important! If an incorrect option is selected, the
Err
message
is displayed for a few seconds and the red
pilot light of this button blinks 3 times.
' appears on
Advertisement
Table of Contents
