Table of Contents
Advertisement
If the outlet spigot has
not been used before, re-
move any blanking plug
that may be in place.
If you intend to drain the hose from the machine into
a sink, make sure that the sink is empty and the plug
hole is not blocked. Use the plastic "U - Piece" sup-
plied.
Special conditions
If the floor is carpeted or covered with crumbly or soft
material, insert a rigid support base under the feet to pre-
vent noise, vibration or displacement. The base should
protrude a few centimetres beyond the edges of the ap-
pliance.
Warning! The appliance should NOT be placed
on deep pile carpeting.
Note!
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
breakdown.
In the interest of the environment
The appliance should be connected to the FOUL drain-
age system, the water will then be taken to a sewage
works for treatment before being discharged safely into
a river.
It is essential that these appliances are not connected to
the surface water drainage system as this water is dis-
charged directly into a river or stream and may cause
pollution.
If you require any further advice please contact your lo-
cal water authority.
Push the drain hose onto
the spigot and secure
with a clip, ensure a loop
is formed in the drain
hose (see above) to pre-
vent waste from the sink
entering the appliance.
SHOWER
BATH
WASHING
MACHINE
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
Electrical connection
Any electrical work required to install this appliance
should be carried out by a qualified electrician or com-
petent person.
Warning! THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should
this safety measure not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance's
rating plate.
Warning! Information on the electrical connection
is given on the rating plate on the inner edge of
the appliance door.
The appliance is supplied with a 13 amp plug fitted.
In the event of having to change the fuse in the plug sup-
plied, a 13 amp ASTA approved (BS1363/A) fuse must
be used.
Should the plug need to be replaced for any reason, pro-
ceed as described below.
The wires in the mains lead are coloured in accordance
with the following code:
SINK TOILET
BIDET
DISHWASHER
FOUL DRAIN
FOUL SEWERS
SEWAGE TREATMENT
WORKS
TREATED DISCHARGE
RIVER
23
Advertisement
Table of Contents
