Travis Industries 1750 Owner's Manual page 32

32
3. Place the insert into the fireplace and connect the flue (if using a positive or direct connection). Install
the top panel and trim following the directions below.
Spring
Clips
Install the top panel so the tabs insert
into the joggle clips on the top panel
Insulation Installation (required only for face seal installations)
1. With the insert drawn 6" from the fireplace, glue the insulation strip included with the insert to the back
of the panels using RTV silicon or stove gasket cement. The insulation should be installed so it
overlaps the fireplace opening to form a seal between the panels and the fireplace face. Let the
silicon or cement dry.
2. Push the insert into the fireplace, allowing the insulation to form a seal between the panels and the
fireplace. Use a screwdriver to tuck any exposed insulation behind the panels.
© Travis Industries
Optional Equipment
Top
Panel
100-01234_000
Top Trim
"L" Bracket
Right Side
Trim
Optional Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Optional Knock-Out
An optional knock-out is provided on both
sides if the power cord is routed behind the
surround panel.
Micro (1/16")
Standard
Screwdriver
4090805