Table of Contents
Advertisement
®ÂØÒňΠApplication Guide
Signal
©
2000 Roland Corporation U.S.
Understanding the Internal Effects (Continued)
Insert Effects
When you want an effect-processed version of a signal to completely
replace the original signal, you'll use an "insert" effect routing. You'll
want to do this when using effects such as dynamic processors, EQs,
mic and amp modelers, rotary speakers, hum cancelers and so on—in
each case you want to wind up with only the processed signal.
An insert effect gets its name from the fact that it's inserted into the
signal's path, causing the signal to take a detour through the effect
Effect
before continuing on its way. In the VM-7000, you can re-direct a signal
into and out of an insert effect in various places.
You can re-direct:
•
an input channel's signal into and back out of an insert effect just
before it reaches the channel EQ.
•
an input channel's signal into and back out of an insert effect just
before it reaches the channel fader.
•
a multi in channel's signal into and back out of an insert effect just
before it reaches the channel EQ.
•
a multi in channel's signal into and back out of an insert effect just
before it reaches the channel fader.
•
an internal Flex Bus's signal into and back out of an insert effect.
•
an external Flex Bus's signal into and back out of an insert effect.
•
the system's main output into and back out of an insert effect.
•
the system's monitor output into and back out of an insert effect.
We'll describe how to set up an insert effect in a few moments.
How Effects 1 and 2 Can Be Inserted
Effects 1 and 2—the effects that ship with every VM-7000—are the
system's most flexible effects. You can:
•
insert them on any input and multi in signal at any time.
•
insert them on external Flex Busses if you want to send a group of
signals through internal effects.
•
insert them on the system's main and monitor outputs.
How Effects 3-8 Can Be Inserted
Effects 3-8—the effects produced by up to three optional VS8F-2
boards—provide insert processing for specific input or multi in channels.
This VS8F-2...
A
B
C
When you wish to insert the two effects supplied by an optional VS8F-2,
you begin by assigning the VS8F-2 to the desired input or multi input
channels using the following procedure:
1. Press EFFECTS 1-8.
2. Press CURSOR DOWN to select the bottom row of parameters.
3. Press F6 [JUMP].
4. Use the CURSOR buttons to select the desired VS8F-2.
5. Turn V1 [SELECT] to choose INPUT or MULTI IN. For our
example, choose INPUT for all of your VS8F-2s.
6. Press F1 [SET] and F5 [OK] to execute each change.
Getting Started with the VM-7000
Getting Started with the VM-7000
...provides:
...for inserting on Input or Multi In:
Effects 3 and 4
Effects 5 and 6
Effects 7 and 8
Channels 1-4, 13-16
Channels 5-8, 17-20
Channels 9-12, 21-24
2796US, v1.0
Page 27
Advertisement
Table of Contents
