Table of Contents
Advertisement
Quick Installation Guide
Memory Configurations
DIMM1
RAM Type
Size
Note: This mainboard requires 3.3V DIMM with an access time of 70ns
or less, it supports memory size from 8 to 512MB and you may use
any combination of DIMMs in the banks.
Connectors and Jumper Settings
CMOS clear: JP3
Retain CMOS
2Ð3
data (default)
Clear CMOS data
1Ð2
Power supply selection Jumper: JP12/JP15/JP16
AT Power Supply (default)
ATX Power Supply
ATX Power Supply On/Off Switch: PW/SW
Connect your power switch to this jumper (momentary switct type).
CE Test Jumper Pins: JP6/JP7/JP11
These connectors are reserved for the CE test. If you run into any
problems during the CE test, unplug these jumper pins and try again.
Default I/O Settings
PORT
LPT1
COM1
COM2
Note: If the default I/O settings conflict with those of other I/O cards,
such as soundcards you will have to adjust the settings of one of
them. The default settings for the onboard I/O can be changed in
the BIOS setup. Enter BIOS Setup by pressing <Delete> key
during boot-up. The I/O settings can be found under ÒIntegrated
PeripheralsÓ.
DIMM BANKS
DIMM2
EDO/SDRAM
8/16/32/64/128
USB1 and 2 (J3)
Connect your USB devices to these
headers
wake on LAN jumper: JP9
Please connect the WOL cable from
your LAN card to this jumper.
JP12: 1Ð2 & 3Ð4
JP15: 1Ð2
JP16: Open
JP12: Open
JP15: Open
JP16: Close
I/O Address
378H
3F8H
2F8H
DIMM3
CPU Cooling Fan: FAN (JP10)
pin
function
RESET
Connect the reset
button to this
jumper.
SPEAKER
Connect the cable
of speakers to this
jumper
TB Led
Connect your
Turbo led to this
jumper.
IRQ
Functionality
7
ECP + EPP
4
3
39
1
2
3
GND
12V
sensor
HDD
Connect the HDD
led to this jumper.
Keylock
Connect keyboard
lock switch to this
jumper
PRT
printer cable
header
Ð
Ð
Advertisement
Table of Contents
