White W3300 Instructions Manual page 16

01/22/2008
3. Guide the thread through the machine and the bobb
winding guide as marked with the dotted line.
4. Guide the thread through the small hole in the side of ft
bobbin from the inside, Holding the thread end, push t[
bobbin winder shaft to right.
*
Match the groove of the bobbin with the spring on the shaft
o
Spring on the shaft
• Groove in the bobbin
5. Holding the thread end, press the START/STOP" butto
Wind the thread a few times around the bobbin and pre
the "START/STOP" button again.
Trim the excess thread from the top of the bobbin after ft
machine stops.
* it is important to trim the thread close to the bobbin.
6. Press the "START/STOP" button. The machine will ste
automatically when the bobbin is full. Press th
"START/STOP" button to stop at any time or when th
bobbin has stopped moving and the motor is still running.
o
"START/STOP" button
7. Push the bobbin shaft to the left. Remove the bobbin an
continue sewing.
8. Set the bobbin into the shuttle as shown on page 15.
It's a good idea to have several full bobbins oi
hand before start your project.