Maintenance And Care; Cleaning The Foam Filter - Bissell 93Z6 SERIES User Manual

M
aintenance and care
cleaning the dirt container
additional steps can be taken to clean
the dirt container as necessary.
1. Ensure the dirt container has been
emptied.
2. Remove the lower portion by pressing the
front latch on the upper portion as shown.
3. Clean the screen with a cloth or soft brush
to remove dust or debris.
4. If desired, the lower dirt container may be
washed in warm water. Make sure it is
completely dry before reassembling.
do not put in dishwasher.
5. To reassemble, hold the carry handle and
place the upper portion into the lower
portion, lining up the front and back
latches. Push down until both latches click
into place. Make sure the dirt container is
securely assembled before replacing it on
machine.

cleaning the foam filter

the pre-motor filter should be checked
monthly and washed as needed to
maintain performance. More or less
frequent cleaning may be required
based on individual vacuuming habits
and types of debris picked up .
1. The foam filter is located in the tray
labeled "Filter" underneath the dirt
container. Pull the tray out to access
the filter.
2. Remove foam filter from tray and hold
under running water to wash. Mild deter-
gent may also be used if desired. Wring
excess water from filter. air dry thor-
oughly before replacing.
10
w w w . b i s s e l l . c o m
WaRning:
To reduce the risk of
electric shock, turn power
switch OFF and disconnect
polarized plug from electri-
cal outlet before performing
maintenance or
troubleshooting checks.
2.
5.
WARNING:
Do not operate the cleaner with a
damp or wet filter or without all
the filters in place.
1.
8 0 0 . 2 3 7 . 7 6 9 1
3.