Bissell 93Z6 SERIES User Manual page 5

A
ssembly
tool required: phillips screwdriver
1.
Slide upper handle onto lower handle.
Insert one screw into hole marked with
an arrow and tighten until snug.
2.
Attach hose by lining up the tabs on the
collar with the corresponding notches on
the back of the vacuum as shown. Turn
clockwise to lock the hose into place.
3.
Wrap the hose by routing it down and
into the lower hose clip then up and over
the top of the handle. Insert the hose
wand fully into the hose base.
note: it is important that the hose
is fully inserted into the base for
the suction air to be directed prop-
erly to the foot during floor vacu-
uming.
4.
Store TurboBrush on the front of the
handle by aligning the slot at the bottom
with the tab and snapping into place.
5.
Place crevice tool inside telescoping
extension wand. Store tools on vacuum
as shown.
w w w . b i s s e l l . c o m
caution:
Do not plug in your vacuum
cleaner until you are familiar
with all instructions and
operating procedures.
1
3
5
8 0 0 . 2 3 7 . 7 6 9 1
2
4
5