Optional Stand; How To Scan; Power Supply - Datalogic Magellan 1100i Quick Reference Manual

Optional Stand

An optional stand is available for the scanner which can be per-
manently attached to a wall or countertop. After locating the
stand in an optimal position, the scanner (along with the stand)
can be detached for portable use by lifting the entire unit as
shown below.

Power Supply

1
Models require either a Listed class II or class III with a Limited
Power Source (LPS). For the safety certification to be valid, class
III input power sources must be IEC/EN60950-1 (EN 60335-
series, EN 60065 or relevant) approved.
Max. Current: 2.5 A
Input: 100 - 240 VAC Output: 5 VDC
Max. Power: 12.5 W
System Input Voltage
Input: 4.5 - 14.0 VDC Max. Power: 2.5 W

How to Scan

barcodes can be presented to the scanner while it is resting on the
counter or in the optional stand, or the scanner/mount can be
lifted and held as shown.
Optional Scan Button Shown
*Optional Stand
1. Power Off the Terminal (POT) units do not require a power supply.
®
2 Magellan 1100i