Table of Contents
Advertisement
Writing a new
message
16 Menu: Messages*
Your handset can be used to send and receive text messa-
ges. These messages can be stored in a list with up to 10
entries.
There are normal and urgent messages which are signalled to
the recipient in different ways. Every stored message is
displayed in the message list with the first few words of the
message and can be shown in full length by means of
≤/≥
Options
is marked with a time stamp*, and it is possible to monitor
the time stamp for each message via
Details
. The following symbols in front of the message
indicate it's status:
¬ urgent message
‹ normal message read
∫ normal message unread
√ transmitted message confirmed
‚
transmitted message not yet confirmed
x
message could not be transmitted successfully
messages in the list downloaded from the PC
All entries in this chapter are started in idle state by pressing
the softkeys:
≤/≥
Menu
Then select...
≤/≥
Options
≤/≥
OK
ber
If the message list is not full, you can use the
and enter new text. Refer to the key assignment for entering
characters.
After entering the text and pressing
enter the phone number After pressing
select whether it is a normal or urgent message.
OK
If you press
again after that, the message is sent.
*Only useable if supported by your telephone system
OK
Read
. Every received message
OK
Messages
...
Z
New
until
new text
Normal Message
/
OK
≤/≥
Options
Z
OK
new num-
Urgent Message
New
function
, you will be asked to
OK
again, you can
OK
25
Advertisement
Table of Contents
