Installing Hand Crank Handles; Horizontal Handles/Delrin Handles; Vertical Handles; Tri-Pin Quad Handles - Invacare Force Owner's Operator And Maintenance Manual

SECTION 9—OPTIONS

Installing Hand Crank Handles

NOTE: For this procedure, refer to FIGURE 9.9.
Horizontal Handles/Delrin
Handles
1. Secure handle to hand crank with the
screw (Detail "A").
2. Remove the screw to remove handle
from handcrank.

Vertical Handles

1. Position handle onto crank (Detail "B").
2. Tighten set screw to secure handle to
crank.
3. Reverse STEPS 1‐2 to remove handle.

Tri-pin Quad Handles

1. Remove/install tri‐pin quad handles.
Refer to Vertical Handles on page 64
2. Loosen socket screws to adjust handle
position (Detail "C").
3. Tighten socket screws to secure
handles in desired position.
V or S Crank Handles
Replacement/installation of V or S crank
handles should be done by a qualified
technician.

Installing V/S Crankarm Handles

For Models Made Before 7/12/07

Failure to install handle assembly properly could result in injury.
It is recommended to inspect this assembly prior to and after each use.
NOTE: For this procedure, refer to FIGURE 9.10 on page 65.
1. Secure the handle to the crankarm housing using the bolt, spacer, and two bearings.
Recumbent Handcycle Series
DETAIL "A" - HORIZONTAL
HANDLES/DELRIN HANDLES
Horizontal Handle
DETAIL "B" - VERTICAL HANDLES
Set Screw
Vertical Handle
DETAIL "C" - TRI-PIN HANDLES
Socket
Screw
FIGURE 9.9 Installing Hand Crank Handles
WARNING
64
Hand Crank
Screw
Hand Crank
Tri-Pin
Quad
Handle
Part No 1114850