Table of Contents
Advertisement
SECTION 6—RIDING POSITION
Adjusting Seat Fore/Aft - All Models Except XLT Gold
and Top End Force
NOTE: For this procedure, refer to FIGURE 6.6.
NOTE: Seat should be adjusted so that when seated with feet in the footrests, there is a slight bend
at the knee and a slight bend at the elbow when the hand crank is furthest away.
1. If installed, activate parking brake.
2. Loosen, but DO NOT remove the four rear socket screws that secure the rear seat
frame to the handcycle frame.
3. Loosen, but DO NOT remove the two front socket screws that secure the front of the
seat frame to the handcycle frame.
NOTE: There are socket screws on the right and left side of the handcycle.
4. Loosen, but DO NOT remove the hex bolts and locknuts that secure the two seat angle
adjustment clamps to the rear seat supports.
NOTE: There is one clamp on the right and left side of the handcycle.
5. Perform one of the following:
• Moving the Seat Rearward ‐ While lifting up on the back support tubes, push the
seat rearward to the desired position.
• Moving the Seat Forward ‐ While pushing down on the back support tubes, pull
the seat forward to the desired position.
6. Tighten the six socket screws that secure the seat frame to the handcycle frame
securely.
7. Tighten the hex bolts and locknuts that secure the two seat angle adjustment clamps
to the rear seat supports securely.
Back Support Tube
Seat Angle
Adjustment
Clamps
Rear Socket Screws
FIGURE 6.6 Adjusting Seat Fore/Aft - All Models Except XLT Gold and Top End Force
Recumbent Handcycle Series
Handcycle
Seat Frame
Frame
36
Height Adjustment Clamp
Front Socket Screw
Height Adjustment Bracket
Part No 1114850
Advertisement
Table of Contents
