Updating The Firmware - Yamaha CRX-N560 Owner's Manual

Updating the firmware

When new firmware is released, a message to update your current firmware will be shown on the front panel display (when the unit is connected to the Internet
only). In this page, an updating method via a network using the option setting is shown.
1
Press .
• The option menu is shown on the front panel
display.
2
Select [System Config] with
press .
3
Select [Firm Update] with
press .
4
Select [Network] with /
.
• Update starts.
• When update finishes, messages are shown in the
following order: "Update success.", "Please...", and
"power off!."
5
Unplug the power cable from the wall
outlet and plug it back after about 30
seconds.
• Update is applied.
30
En
/ and
/ and
and press
• Do not operate the unit or disconnect the power
cable and network cables while updating.
• Once the message prompting update is shown on
the front panel display, it will not be shown again,
even if you do not perform updating. However,
when you turn on the unit after the power cable
has been disconnected from the wall outlet for a
while, the message will be shown.
• When Internet speed is not fast enough or the unit
is connected to the wireless network via a wireless
network adapter, network update may not be
possible depending on the condition of the
wireless connection. In this case, try again or
update the firmware using a USB memory device.
1
The firmware can be downloaded from the
OPTION
Yamaha Website.
To update the firmware using a USB memory
device
2 3 4
, ,
You can download the firmware to the USB memory
device, and connect that USB memory device to the
/ ,
USB jack on the unit.
ENTER
• Select [USB] in step 4 and press the ENTER button
to start the update.