Reset Button - Rampage ACD-12 Owner's Manual

the auxiliary input mode, the portable audio
device will now operate through the audio
system of the radio using the volume, tone
and balance controls of the radio for
adjustment of the sound.
cp
TIME/FREQUENCY SELECTOR (T/F)
This unit can display either the clock time or
radio frequency/CD player functions. Ordinarily,
the radio frequency or CD player track in-
dication is displayed, but the display can
also show the time when this button is
pressed. The time will then be displayed
for approximately 5 seconds after which it
will return to the radio or CD player function
display.
The correct time-of-day can also be set into
the unit by pressing the Time/Frequency
If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.)
may appear on the display panel. This can indicate a number of problems with the unit, includ-
ing a mechanical error or an error in the microprocessor control of the player. If an error code
should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit,
make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try
activating the RESET button
If the suggested measures do not solve the problem, contact an approved warranty station near
you for further assistance.
1. Turn the vehicle ignition and radio on.
2. Press and hold the Time/Frequency button
display will begin to flash.
3. Within 5 seconds of selecting the flashing display, press the VOL + button to adjust the
hours and the AM/PM indication to the desired setting.
4. Press the VOL - button to adjust the minutes to the desired time.
4. Five seconds after the last hour or minute adjustment is made, the time will be set in the
unit and normal operation will resume.
Selector button. This procedure is outlined
later in these operating instructions.
cq

RESET BUTTON

A Reset button is located on the front panel of the
unit to the right of the LED display. The Reset
function is provided to protect the microproces-
sor circuitry and should only be activated under the
following circumstances as it will erase the time
and pre-set memories:
1. Upon initial installation after all wiring is
completed.
2. If there is a malfunction of any of the switches
on the unit, pressing the Reset button may
clear the system and return to normal opera-
tion.
CD PL CD PLA A A A A YER ERR CD PL YER ERR YER ERROR CODES YER ERR OR CODES OR CODES OR CODES
CD PL CD PL YER ERR OR CODES
?G
on the unit, but this will also erase the time memory.
SET SET T T T T T ING THE CLOCK SET SET SET ING THE CLOCK ING THE CLOCK ING THE CLOCK ING THE CLOCK
cp
for approximately 2 seconds; the time
128-6196A
11 of 16
11 11 11 11 11