Procedure 6 - Seat-To-Floor Heights; Changing Seat-To-Floor Height- Tracer Ex Only - Invacare 9758 Owner's Operator And Maintenance Manual

PROCEDURE 6
This Procedure Includes the Following:
Changing Seat-To-Floor Height-Tracer EX Only
D
E
A
L
After ANY adjustments, repair or service and BE-
E
R
FORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage
A
may result.
D
J
NOTE: Tracer IV, Tracer Transport and Invacare MG:
U
S
Seat to floor height not adjustable.
T
M
CHANGING SEAT-TO-FLOOR HEIGHT-
E
TRACER EX ONLY (FIGURE 1)
N
T
S
When changing the seat-to-floor height you
must adjust the anti-tippers accordingly.
NOTE: Invacare recommends that the following proce-
dure be performed by an authorized dealer or qualified
technician.
FIGURE 1 - CHANGING SEAT-TO-FLOOR HEIGHT - TRACER EX ONLY
WARNING
WARNING
TRACER EX FRAME
Seat-to-Floor Front Caster
Height
(In Inches)
21 8-inch
21 6-inch
20 6-inch
19 6-inch
NOTE: 6-inch and 8-inch casters require different forks.
8-INCH FORK
MOUNTING POSITION
1. Remove the rear wheels from the wheelchair. Refer
to REMOVING/INSTALLING THE REAR WHEELS
in PROCEDURE 4 of this manual.
2. Remove the front casters from the wheelchair. Re-
fer to INSTALLING/REPLACING SIX OR EIGHT
INCH FRONT CASTERS & FORKS in PROCE-
DURE 5 of this manual.
3. Refer to the charts of front caster/fork and rear wheel
sizes, to determine mounting positions for obtain-
able seat-to-floor heights in FIGURE 1.
4. Reinstall the front casters onto the wheelchair. Refer
to INSTALLING/REPLACING SIX OR EIGHT INCH
FRONT CASTERS & FORKS in PROCEDURE 5
of this manual.
5. Reinstall the rear wheels onto the wheelchair. Refer
to REMOVING/INSTALLING THE REAR WHEELS
in PROCEDURE 4 of this manual.
6. Adjust anti-tippers as necessary. Refer to ADJUSTIING
THE ANTI-TIPPERS in PROCEDURE 7 of this manual.
Front Caster
Size Mounting
Position
N/A
Bottom
Middle
Top
6-INCH FORK
MOUNTING POSITIONS
22
SEAT-TO-FLOOR HEIGHTS
Rear Wheel
Size
24-inch
24-inch
22-inch
20-inch
Top
Middle
Bottom