Procedure 3 - Seat And Back; Fold Down Back - Tracer Transport Only; Replacing Back Upholstery; Replacing The Seat Upholstery - Invacare 9758 Owner's Operator And Maintenance Manual

Invacare wheelchair owner's operator and maintenance manual
Table of Contents

Advertisement

PROCEDURE 3
This Procedure Includes the Following:

Fold Down Back - Tracer Transport Only

S

Replacing Back Upholstery

E

Replacing the Seat Upholstery

A

Adjusting Seat Width

T
A
After ANY adjustments, repair or service and BEFORE
N
use, make sure all attaching hardware is tightened
D
securely - otherwise injury or damage may result.
B
FOLD DOWN BACK - TRACER
A
C
TRANSPORT ONLY (FIGURE 1)
K
Folding
1. Lift up on the two (2) release levers on the back canes.
2. Pull back on the handles to the desired position.
Unfolding
Make sure the release levers are securely
locked in place BEFORE using the wheelchair.
1. Pull up on the two (2) back canes until the release
levers lock in place.
NOTE: There will be an audible click.
2. Pull on the handles to make sure the back is locked
in place.
Handle
Release Lever
FIGURE 1 - FOLD DOWN BACK - TRACER
TRANSPORT ONLY
REPLACING THE BACK
UPHOLSTERY (FIGURE 2)
1. Remove the screws and washers that secure the
existing back upholstery to the back canes.
2. Position new back upholstery on back canes as
shown in FIGURE 2.
WARNING
WARNING
Back Cane
3. Securely tighten the new back upholstery to the back
canes with the screws and washers.
Washers
Screws
FIGURE 2 - REPLACING BACK UPHOLSTERY
REPLACING THE SEAT
UPHOLSTERY (FIGURE 3)
1. Remove the eight (8) screws that secure the exist-
ing seat upholstery to the crossbraces.
2. Remove the existing seat upholstery from the
crossbraces.
3. Install the new seat upholstery by reversing STEPS 1-2.
Screws
FIGURE 3- REPLACING THE SEAT UPHOLSTERY
ADJUSTING SEAT WIDTH
Adjusting the seat width of the wheelchair MUST
be performed ay an authorized Invacare dealer
or qualified technician.
Removing Lower Mounting Hardware
(FIGURE 4)
1. Remove the existing back and seat upholstery from
the wheelchair. Refer to REPLACING THE BACK
UPHOLSTERY and REPLACING THE SEAT UP-
HOLSTERY in this section of the manual.
NOTE: If adjusting the seat width of the wheelchair, back and
seat upholstery as well as the crossbraces MUST be replaced.
2. Remove the four (4) screws and locknuts that se-
cure the insert tube to the lower wheelchair frame.
18
SEAT AND BACK
Back Upholstery
Washers
Seat Upholstery
WARNING

Advertisement

Table of Contents
loading

This manual is also suitable for:

9859Tracer exTracer ivTracer transportMg

Table of Contents