Advertisement
4. Connect the base station radio modem as shown below. Plug the power adapter into a
wall outlet and make sure the radio modem's Power light comes on.
BASE STATION:
5. Supply power to the weather station using the 200mA power adapter supplied with
the station.
6. Use the Test (or Connection Test) button in the WeatherLink software's serial port
dialog box to make sure you can successfully connect to the field radio modem/
weather station.
Consult the software manual for instructions on selecting the correct serial
port settings and testing the connection.
7. If successful, continue with the installation.
If you receive an error message, try testing the connection again. If you are
still not able to successfully connect, consult "Troubleshooting" on page 32.
Note: If there is a problem with interference from another radio source, try changing channels. Re-
Testing the Radio
Radio Modem
configure all of the radio modems (see "Configuring The Radio Modem" on page 11). You
may choose between three channels; make sure all radio modems are set to the same chan-
nel.
To Power Adapter
To PC
®
WeatherLink
PC RADIO
L2
DB-25 Adapter
Part
7943
To Antenna
Page 15
Advertisement
