Displaying The Port Status - Brocade Communications Systems Gateway Administrator's Manual

4
Determining the mapping and port status
To display an N_Port map
1. Connect and log in to the switch.
2. Enter the ag
N_Port
Failover
Failback
Current F_Ports
Configured F_Ports

DISPLAYING THE PORT STATUS

This section explains how to determine the ports status.
To display the port status
1. Connect and log in to the switch.
18
switch:admin> ag --mapshow
N_Port Configured_F_Ports
-------------------------------------------------------------------------
0 9;10
17 None
18 3;4
19 None
20 None
21 1;2;11;12
22 5;13;14
23 6;15;16
-------------------------------------------------------------------------
mapshow command and specify the port number to display the N_Port failover
--
and failback policies and the mapped F_Ports.
Number of the port.
Indicates whether or not the failover policy is enabled (1) or disabled
(0) on the N_Port.
Indicates whether or not the failback policy is enabled (1) or
disabled (0) on the N_Port.
Shows the F_Ports that are currently connected to the fabric on this
N_Port.
In the case of failover, the Current F_Port and Configured F_Ports
differ. For example (shown below), 8 failed over to this port from
another port.
Indicates the ports which are mapped to this N_Port.
switch:admin> ag --mapshow 0
N_Port
Failover(1=enabled/0=disabled) : 1
Failback(1=enabled/0=disabled) : 1
Current F_Ports
Configured F_Ports
Current_F_Ports
None
None
None
None
None
1;2
5;9
6;10
: 0
: 2;8;
: 2;
Access Gateway Administrator's Guide
Failover Failback
1 1
1 1
1 1
1 1
1 1
1 1
1 1
1 1
53-1000633-01