Advanced Functions Available during Calls
Pause during calls (Hold function)
@@ @@
�
Holding tone is
transmitted to the
Busy
other party.
When the remote set is busy
To hold during a call, press
To resume the call, press
36
To resume the call
�
�
When using the handset
To resume the call
�
�
When placing the handset
Pick up the handset or
press
button.
● If the other party does not
pick up the phone even after
�3 minutes�, the holding
tone is automatically
disconnected.
button.
button again.
Advanced Functions for Auto Answering
Functions used for Auto Answering
1. Voice message record time
These functions are set as
default when the auto
answering function is used.
● The time allowed for the caller to leave a message on the auto answering machine is 3 minutes.
● Correct date and time at which the message is left is announced only when the date and time is set
in the unit.
2. Auto Answering Ring Count
● The auto-answering bell count can be setup respectively for both auto-answering on and off.
● If the caller does not speak a word for 10 seconds for recording on the auto answering
machine, the call is automatically terminated.
Checking the caller' s voice
When the caller is leaving
a message in the auto
Setting the caller
answering mode, you can
identification
hear his or her voice
through the speaker.
Canceling the caller
identification
Confirming the caller
identification
(Time when the message is recorded by the callers)
(Ansewring Ring Count : The number of rings before
the unit switches to auto answering mode when there
is an incoming call)
(Caller Identification)
�
�
�
�
�
�
�
�
�
�
37