Flymo 1200 R Installation Manual page 57

Message
No drive
Charging station
blocked
Stuck in charging
station
Upside down
Needs manual
charging
Next start hh:mm
The day's mowing is
complete
9. TROUBLESHOOTING
Cause
The robotic lawnmower has got
caught in something.
The working area includes a steep
slope.
The guide wire is not laid at an angle
on a slope.
The contact between the charging
strips and contact strips may be poor
and the robotic lawnmower has made
a number of attempts to charge.
An object is obstructing the robotic
lawnmower.
There is an object in the way of the
robotic lawnmower preventing it from
leaving the charging station.
The robotic lawnmower is leaning too
much or has turned over.
The robotic lawnmower is set in the
MAN operating mode.
The timer setting prevents the robotic
lawnmower from operating.
The rest period is in progress. The
robotic lawnmower must dock in the
charging station for at least 11 hours
a day.
The rest period is in progress. The
robotic lawnmower must dock in the
charging station for at least 11 hours
a day.
Action
Free the robotic lawnmower and
rectify the reason for the lack of drive.
If it is due to wet grass, wait until the
lawn has dried before using the
robotic lawnmower.
Maximum guaranteed slope is 25%.
Steeper slopes should be isolated.
See 3.4 Installation of the boundary
wire on page 21.
If the guide wire is laid on a slope, it
must be laid at an angle across the
slope. See 3.6 Installation of the
guide wire on page 28.
Put the robotic lawnmower in the
charging station and check that the
charging strips and contact strips
make good contact.
Remove the object.
Remove the object.
Turn the robotic lawnmower the right
way up.
Place the robotic lawnmower in the
charging station. This behaviour is
normal and no action is required.
Change the timer settings. See
6.3 Timer on page 43.
This behaviour is normal and no
action is required. See 4.2 Using the
timer on page 35.
This behaviour is normal and no
action is required. See 4.2 Using the
timer on page 35.
English - 57