Air-Conditioners INDOOR UNIT PEA-RP170, 200, 250 WGA FOR USER OPERATION MANUAL For safe and correct use, please read this operation manual thoroughly before operating the air-conditioner unit.
Page 2
[Fig. 2.0.1] [Fig. 2.0.2] TEMP. ON/OFF A Air outlet A LCD remote controller B Air inlet C Air filter [Fig. 5.0.1] A Air outlet C Air filter B Air inlet D Air filter handle...
• Make sure that there is a main power switch. • Use only accessories authorized by Mitsubishi Electric and ask your • Be sure to adhere to the unit’s voltage and fuse or circuit breaker ratings. dealer or an authorized company to install them. If accessories are in- Never use a piece of wire or a fuse with a higher rating than the one stalled improperly, water leakage, electric shock or fire may result.
1.2. During operation In case of failure Warning: Caution: • Never remodel the air conditioner. Consult your dealer for any repair serv- • Do not use any sharp object to push the buttons, as this may damage the ice. Improper repair work can result in water leakage, electric shock, fire, remote controller.
3. Operation Remote controller-Button TEMP. ON/OFF MENU ON/OFF FILTER BACK MONITOR/SET CHECK TEST Opening the door. PAR-21MAA CLOCK OPERATION CLEAR 0 Filter button (<Enter> button) 1 Set Temperature buttons A Test Run button Down B Check button (Clear button) C Airflow Up/Down button 2 Timer Menu button (Monitor/Set button) 3 Mode button (Return button) Notes:...
When stop continues for 10 minutes, the compressor and indoor fan are oper- ated for 3 minutes to keep the humidity low. For heating Press the 2 2 2 2 2 [operation mode] button to bring up the “ HEAT” display. Regarding displays during heating operation “DEFROST”...
s How to Set the Weekly Timer Notes: • It can be set regardless of the operation of the indoor unit. 1. Be sure that you are at a standard control screen, and that the weekly timer indicator 1 is shown in the display. •...
Page 8
s How to Set the Simple Timer Note: Your new entries will be cancelled if you press the Mode (Return) button 2 2 2 2 2 Timer Setting button 4 4 4 4 4 . before pressing the Filter If you have set two or more different operations for exactly the same time, Action (On or Off) only the operation with the highest Operation No.
Page 9
Examples When something other than the Auto Off Timer is displayed, set it to AUTO If ON and OFF times have both been set at the simple timer, operation and display OFF TIMER using the function selection of remote controller (see Installa- are as indicated below.
3.7. Locking the remote controller buttons 3.8.2. Flashing Mode Indicator (Operation function limit controller) I If you wish, you can lock the remote controller buttons. You can use the Func- tion Selection of remote controller to select which type of lock to use. (For ˚C information about selecting the lock type, see Installation Manual).
4. The smart way to use Even minimal steps to care for your air conditioner can help make its use far Prevent intrusion of heat during air-cooling more effective in terms of air-conditioning effect, electricity charges, etc. • To prevent the intrusion of heat during cooling operation, provide a curtain or a Set the right room temperature blind on the window to block out direct sunlight.
6. Troubleshooting G The unit started even though the start/stop button was not pushed. Before you call out a repair man, check the following table to see whether there is a simple solution to your problem. • Is the timer on? Press the start/stop button to stop the unit.
7. Installation and transferring works, and checking Regarding place for installation Regarding transfer of installation Consult with your dealer for details on installation and transferring the installation. • When removing and reinstalling the air conditioner when you enlarge your home, remodel, or move, consult with your dealer in advance to ascertain the Caution: cost of the professional engineering work required for transferring the installa- Never install the air conditioner where there is a risk of leakage of flammable...
Page 16
Please be sure to put the contact address/telephone number on this manual before handing it to the customer. HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN WT05223X02...