Invacare 1069956 Assembly, Installation And Operating Instructions

MPR Tray Assembly Kit - Model 6905A
Assembly, Installation and Operating Instructions
Kit No. 1108705, 1069956
NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact
Carrier/Dealer for further instruction.
To ensure the safe installation, operation and use of the MPR Tray Assembly
Kit, these instructions MUST be followed:
DO NOT install or use this equipment without first reading and understanding
these instructions. If you are unable to understand the Warnings, Cautions or
Instructions, contact a healthcare professional, dealer or technical personnel before
attempting to install this equipment - otherwise injury or damage may occur.
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
MPR Tray Assembly Kit (Part No. 1108705) contains the following items:
DESCRIPTION
Tray*
Pivot Arm
Support Arm
Tray Tab
Flange Screw
Dome Plug
*Tray (Part No. 1069956) can also be ordered separately.
REPLACING THE TRAY - MODEL 6905A (FIGURE 1)
1. Remove tray from recliner. Refer to STORING/REMOVING THE TRAY in the
Owner's Manual, part number 54000M107.
2. Position tray assembly on the floor as shown in FIGURE 1.
3. Remove the four (4) flange screws and two (2) tray tabs that secure the support arm
to the tray.
4. Remove the four (4) flange screws and two (2) tray tabs that secure the pivot arm to
the tray.
5. Remove existing tray.
NOTE: Retain ALL mounting hardware and arms if only installing new Tray, part number 1069956.
For more information regarding Invacare products, parts, and services,
Part No. 1123847
SAVE THESE INSTRUCTIONS

SAFETY SUMMARY

GENERAL WARNING
INSTALLATION WARNING
please visit: www.invacare.co
1
QUANTITY
1
1
1
4
8
2
m
MPR Tray Assembly Kit