Download Print this page

Invacare 1048919 Assembly, Installation And Operating Instructions

Back cane replacement kits for 9000 series wheelchairs

Advertisement

Quick Links

Back Cane Replacement Kits
for 9000 Series Wheelchairs
Assembly, Installation and Operating Instructions
Kit Nos. 1048919, 1048920, 1048921, and 1048922
NOTE: These instructions apply to the 9000 XT/XDT and the 9000 SL with adjustable 
back angle option.
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact 
Carrier/Invacare for further instructions.
DO NOT install this equipment without first reading and understanding this
instruction sheet. If you are unable to understand the warnings, cautions and
instructions, contact a healthcare professional, dealer or technical personnel
if applicable, before attempting to install this equipment - otherwise, injury or
damage may occur.
Invacare products are specifically designed and manufactured for use in
conjunction with Invacare accessories. Accessories designed by other
manufacturers have not been tested by Invacare and are not recommended
for use with Invacare products.
After ANY adjustments, repair or service and BEFORE use, make sure that
all attaching component parts are secure.
NOTE: For this procedure, refer to FIGURE 1.
1. Remove the two mounting screws and washers that secure the back upholstery 
to the back canes (Detail "A").
2. Remove the two mounting screws, locknuts, and (for wheelchairs 
manufactured after 11/1/2005) spacers that secure one back cane to the 
wheelchair frame (Detail "C").
3. Pull the loose back cane out of the back upholstery.
4. Slide a new back cane through the back upholstery.
5. Secure the new back cane to the wheelchair frame at the desired back height 
with the two mounting screws, locknuts, and (for wheelchairs manufactured 
after 11/1/2005) spacers (Detail "B").
NOTE: For wheelchairs manufactured after 11/1/2005, the spacers must be on the outside 
of the wheelchair in order for the mounting screws to be properly tightened (Detail "C").
For more information regarding Invacare products, parts, and services,
Part No 1046525
SAVE THESE INSTRUCTIONS

Safety Summary

WARNING
please visit www.invacare.com
1
Back Cane Replacement Kits for 9000 Series

Advertisement

loading

Summary of Contents for Invacare 1048919

  • Page 1: Safety Summary

    Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products. After ANY adjustments, repair or service and BEFORE use, make sure that all attaching component parts are secure.
  • Page 2 18 inches High 16 inches High Wheelchairs manufactured after 11/01/05 NOTE: The spacers  must be on the  outside of the  wheelchair in order  for the mounting  screws to be properly  tightened. Invacare, the Medallion Design, and Yes, you can. are registered trademarks of Invacare Corporation. ©2005 Invacare Corporation Part No 1046525 Rev C - 12/6/05...

This manual is also suitable for:

104892010489211048922