Pride Victory Viper Owner's Manual page 20

I V . Y O U R V I C T O R Y V I P E R
REAR SHROUD
The rear shroud is a removable plastic piece that protects the rear section and its subcomponents. In order
to remove the rear shroud, you must first remove the seat from your scooter (see VII. “Comfort Adjustments”),
and then lift the rear shroud gently until it disengages from the reusable fasteners holding it in place.
Finally, disconnect the rear light harnesses to fully remove the rear shroud.
REAR SECTION
The batteries, electronic controller module, motor/transaxle assembly, manual freewheel lever, the anti-tip
wheels, the main circuit breaker, and the fuses (not shown) are located on the rear section of your scooter.
See figure 9.
Batteries
The batteries store the electrical energy that powers your Victory Viper. For instructions on charging your
batteries, see V. “Batteries and Charging.”
BATTERIES
ELECTRONIC CONTROLLER
MODULE
BATTERY CHARGER
CHARGER POWER LEAD
AMMETER
RECEPTACLE
MAIN CIRCUIT BREAKER
(RESET BUTTON)
MANUAL
FREEWHEEL
MOTOR/
LEVER
TRANSAXLE
ASSEMBLY
ANTI-TIP WHEELS
Figure 9. Rear Section
Victory Viper
20