3.2 Configuring With Software
NOTE: If you plan to test your RAM 3000 Deluxe to ensure
you did the board configuration and RAM chip installation
correctly, you should follow this subsection.
1.
Insert the RAM 3000 Deluxe utility diskette in Drive
"A" and type:
A:EV159
<Enter>
2.
You will see ten available menu selections: Amount of
Existing Base Memory, Amount of Existing Extended Memory,
Amount of Base Memory to be Added, Amount of Extended
Memory to be Added, EMS I/O Port Address (For The First
2M (megabytes) of EMS), EMS I/O Port Address (For EMS
Above 2M (megabytes)), EMS Fast Mode (Y/N), Are DRAMs
120 ns (nanoseconds) or Faster (Y/N), and Enable Parity
Checking (Y /N).
3.
Use the up and down cursor keys to select among the
ten menu fields; if you need help on each field when
you do your software board set up, press the
[Fl]
function key for a help screen pertaining to that menu
field.
4.
When you finish configuring, press the [F2] function
key for a screen representation of the board; configure
the dipswitches and jumpers according to the screen
representation, and note the number of memory banks
12