The Transmitter - Pet Stop Pet Fence System Owner's Manual

The Transmitter

Your transmitter comes complete with these standard features:
Built-in Lightning Protection with Zapp Alert
Traditionally, lightning is one of the most common causes of transmitter failure. Pet Stop has
developed built-in surge and over-voltage protection for both the electrical outlet and any high
voltage carried by the buried wire in your yard.
To add extra protection for you and your pet, we have added Zapp Alert
feature should lightning damage your unit. If your transmitter experiences an electrical surge, the
transmitter will continue to sound two short beeps. If this happens, contact your local Pet Stop
dealer for service immediately.
Remember: Do not allow your pet outside during a lightning storm.
Wire Break Warning System
Your transmitter also has a built-in sensor which monitors the boundary wire. If, for any reason,
the wire becomes broken, the transmitter display will flash and a continuous single beep will alert
you to the problem. Unplug the transmitter and contact your local Pet Stop dealer to assist you in
locating and repairing the wire break correctly.
Fully Adjustable Signal Field
Your transmitter is also completely adjustable. Press the up and down buttons located on the front
of the transmitter to adjust the signal field for your specific installation. Press the UP button to
increase the signal field width or press the DOWN button to decrease the signal field width. The
digital display has a range from 01 to 32. For example, if your range is set to 16 this indicates there
is 8 feet of signal field on either side of the boundary wire for a total of 16 feet.
Your Pet Stop dealer has set the signal field range appropriate for your installation.
Before adjusting the signal field width contact your dealer.
We recommend that your dog be on a leash or carefully supervised if the transmitter
is not functioning.
Turning the Transmitter On and Off
If you are going to be away for extended period of time and want to turn off the transmitter, press
the two black buttons simultaneously. To turn the transmitter back on, press the top button. It is
not necessary to reset the transmitter. Remember, when the transmitter is turned off, the Pet Stop
receiver collar will not activate.
Warning
®
, an audio-visual indication
®
5