Assembly - Kid Kustoms Roddlec Owner's Manual

trike assembly instructions
Get Started
1
Use the two included
8MM screws [A] to attach
front stem chassis and
pedal wheel assembly
[B] to rear chassis [C].
Be sure to fully tighten
screws.
C
2
Thread the seat post
[D] into the center of the
chassis [C] and tighten the
safety nut firmly against
the chassis to avoid
rotation. Then Slide the
Seat [E] on the top of the
seat post.
A
If transforming your Roddler Stroller into an Enzo Trike, follow
Accessory Conversion Kit assembly instructions, page 15.
18
3
Tighten the two ½" nuts
on the side of seat bracket
to keep the seat from
spinning. To adjust the
seat for shorter legs, slide
the seat forward on the
seat post bracket before
tightening the ½" nuts.
D
E
B