Assembly - Kid Kustoms Roddlec Owner's Manual

conversion kit assembly instructions
Assemble Enzo Trike
1
Attach stroller handlebar
and headset [A] to the
the Trike front chassis
assembly [C].
2
Use the two included
8MM screws [B] to attach
trike front chassis [C] to
rear chassis [D]. Be sure
to fully tighten screws.
3
Thread the seat post
[E] into the center of the
chassis [D] and tighten the
safety nut firmly against
the chassis to avoid
rotation. Then Slide the
Seat [F] on the top of the
seat post.
D
B
If you are assembling an Enzo Trike, follow Trike assembly
instructions, page 18.
3
E
15
Tighten the two ½" nuts
on the side of seat bracket
to keep the seat from
spinning. To adjust the
seat for shorter legs, slide
the seat forward on the
seat post bracket before
tightening the ½" nuts.
A
C
F