Advertisement

Quick Links

Owner's
Manual
6months - 6yrs or Max Weight 37.5 lbs (17kgs)
ASTM and EN Safety Standard Certifi ed
This product is NOT suitable for running or skating. For safety reasons, do
not modify this product in any way, except with Kid Kustoms certifi ed parts.

Advertisement

Table of Contents
loading

Summary of Contents for Kid Kustoms Roddlec

  • Page 1 Owner’s Manual 6months - 6yrs or Max Weight 37.5 lbs (17kgs) ASTM and EN Safety Standard Certifi ed This product is NOT suitable for running or skating. For safety reasons, do not modify this product in any way, except with Kid Kustoms certifi ed parts.
  • Page 2 WWW.KIDKUSTOMS.COM...
  • Page 3: Table Of Contents

    Congratulations on your purchase. Please read this owner’s manual completely before assembling or operating this product, and keep it for future maintenance or reference when communicating with Kid Kustoms customer service. This product should always be assembled or disassembled by an adult. Contents...
  • Page 4: Parts List

    Stroller Included in the Box Stroller front chassis assembly • Stroller rear chassis assembly • 2x 8mm screws • Seat and Canopy • Storage Basket • 6months - 6yrs or Max Weight 37.5 lbs (17kgs) ASTM and EN Safety Standard Certified This product is NOT suitable for running or skating.
  • Page 5: Warnings

    • STROLLER is for use with children who can sit up unassisted, and is NOT recommended for newborns. • Only use accessories and replacement parts approved by Kid Kustoms LLC. Using unapproved accessories could be dangerous.
  • Page 6: Care & Maintenance

    care & maintenance • DO NOT USE ANY CHEMICALS. • To clean the frame and fenders of the stroller, use a simple detail carnuba wax or just a damp cloth towel. • Never use abrasive cleaners on either the plastic section or the frame or bleach near the fabric covers as this may cause discoloration or scratches.
  • Page 7: Assembly

    stroller assembly instructions Get Started Use the two included 8MM screws [A] to attach front chassis [B] to rear chassis [C]. Do not fully tighten screws until after completing Step 2. The perimeter bars connect with a small pin system. Push the small pin down slightly to complete the full perimeter of the seat surround.
  • Page 8 stroller assembly instructions Connecting the Seat • Pull the seat down around the perimeter bars. Fasten the clips on back side of seat to attach the seat securely to the perimeter bars. • Take the two male and female buckles on the underside of the seat and loop them around the seat frame.
  • Page 9 stroller assembly instructions Dual Action Safety Lock TO FOLD TO UNFOLD • Hold the pull pin in release THE STROLLER THE STROLLER position and lift the chassis up [4] until you • Hold down the safety • Hold down the safety hear the pull pin click into lock [1], then pull the pull lock by pressing the...
  • Page 10 Kid Kustoms Signature 5-Point Safety Harness ™ • Press the two red right and left red button at the same time and pull the two red buckle up to release. • Adjust child’s shoulder height straps to firmly hold position while seated in the stroller.
  • Page 11: Assembly

    stroller assembly instructions Front Wheel Lock • The front wheel lock will register when both the front wheel and fender are in the forward position. • To operate, set front wheel to face forward and push in the Locking Arm. Car Seat Carrier Attachment (Optional) • To install the Car Carrier attachment kit, you must...
  • Page 12: Parts List

    Accessory Conversion: Trike Kit Included in the Box Front chassis assembly • Seat and post • 3+ yrs or Max Weight 55 lbs (25kgs) ASTM and EN Safety Standard Certified This product is NOT suitable for running or skating. For safety reasons, do not modify this product in any way, except with Kid Kustoms certified parts.
  • Page 13: Warnings

    Accessory Conversion: Trike Kit WARNING FOR THE SAFETY OF YOUR CHILD, PLEASE READ THE FOLLOWING WARNINGS AND ASSEMBLY INSTRUCTIONS AND KEEP FOR FUTURE REFERENCE. • Adult assembly required. • CAUTION: Keep small parts away from children during assembly • NEVER LEAVE CHILD UNATTENDED. Continuous adult supervision required. •...
  • Page 14: Assembly

    conversion kit assembly instructions Get Started: Disassemble Stroller To remove the stroller headset [A], loosen the two hex bolts on the side and loosen the fl anged cap screw (with Kid Kustoms Logo) on top the of stroller headset. Remove the two 8mm screws [B] that connect the stroller front chassis and rear chassis.
  • Page 15: Assembly

    conversion kit assembly instructions Assemble Enzo Trike Attach stroller handlebar Thread the seat post Tighten the two ½” nuts and headset [A] to the [E] into the center of the on the side of seat bracket the Trike front chassis chassis [D] and tighten the to keep the seat from assembly [C].
  • Page 16: Parts List

    Enzo Trike Included in the Box Chassis assembly • Handlebar headset • 2x 8mm screws • Seat • Headlight (Kustom Trike Only) • 3+ yrs or Max Weight 55 lbs (25kgs) ASTM and EN Safety Standard Certified This product is NOT suitable for running or skating. For safety reasons, do not modify this product in any way, except with Kid Kustoms certified parts.
  • Page 17: Warnings

    Enzo Trike WARNING FOR THE SAFETY OF YOUR CHILD, PLEASE READ THE FOLLOWING WARNINGS AND ASSEMBLY INSTRUCTIONS AND KEEP FOR FUTURE REFERENCE. • Adult assembly required. • CAUTION: Keep small parts away from children during assembly • NEVER LEAVE CHILD UNATTENDED. Continuous adult supervision required. •...
  • Page 18: Assembly

    trike assembly instructions Get Started Use the two included Thread the seat post Tighten the two ½" nuts 8MM screws [A] to attach [D] into the center of the on the side of seat bracket front stem chassis and chassis [C] and tighten the to keep the seat from pedal wheel assembly safety nut firmly against...
  • Page 19: Limited Warranty

    ™ ™ Additionally, all products are protected by a provisional patent; This material may not be reproduced without the prior written permission.For a detailed guideline to govern the use of Kid Kustoms trade marks, please email: pr@kidkustoms.com ™ These conditions of use are governed by the laws of the state of California in the United States of California and you agree that the Californian courts shall have exclusive jurisdiction in any dispute.
  • Page 20 WWW.KIDKUSTOMS.COM ©2014 Kid Kustoms LLC. All Rights Reserved. www.kidkustoms.com | pr@kidkustoms.com Designed in California and Made in China...

This manual is also suitable for:

The roddler

Table of Contents