Table of Contents Pages 1. Introduction 2. Precautions 3. Compatibility Notes 4. Dipswitch Settings 5. Installation 6. iPod Operation 7. HD Radio Operation (if equipped) Selecting AUX Input Selecting Factory Satellite (if equipped) Troubleshooting Warranty Info...
Page 3
Neo Gateway & Optional Add-ons Factory Radio Not Included iPod Neo Gateway Harness Not Included Neo Gateway 11Ft. iPod Cable 3Ft. HD Radio Cable HD Radio Tuner...
1. Introduction Thank you for purchasing the ® Neo Gateway. The Neo Gateway is designed to provide endless hours of listening pleasure from your factory radio. To ensure that your iPod performs correctly with your radio, we recommend that you read this entire manual before attempting installation of the Neo Gateway.
3. Compatibility Notes This section will inform you of the specific requirements for your factory radio to be compatible with the Neo Gateway. These notes will inform you of any issues or circumstances that can affect the compatibility of our product with your radio, audio system, or accessories.
5. Installation 1. When making electrical connections it is always recommended that the vehicle’s battery be disconnected from the electrical system before performing the installation. 2. Carefully remove the trim panels covering the 10mm bolts that secure the radio into the dash cavity.
6. Plug in the male connectors on the TY1 harness into the 12-pin port on the back of the radio. Next, connect the factory 12-pin harness (if present) into the female connector on the TY1 harness. Be sure to make a firm connection but do not force it. Plug the Black micro-fit 24-pin connector on the TY1 harness into the Gateway Neo Gateway box.
Page 8
Browse by Artist Press Preset 3 to enter the browse menu. ”PL: LIST” will appear on your display. Turn the rotary tune knob or Press “SEEK>” until ARTIST is displayed. Press Preset 3 to select browse by Artist. The list of Artists on your iPod will be displayed one at a time in alphabetical order. “AR”...
7. HD Radio Operation Entering Mode Select Menu Press the “AM/SAT” button to switch to AM then again to switch back to SAT. Turn the rotary knob to scroll through the available sources. Once “HD RADIO” is displayed, press PRESET 3 to select the displayed mode. Tune Up Turn the rotary tune knob clockwise manually tune up.
10. Troubleshooting Symptom Cause Remedy Radio shows iPod iPod cable is not Verify the docking cable is connected not connected connected to iPod or to the Neo Gateway, and the iPod Gateway. I can not correctly The iPod firmware Update iPod firmware for free at http:// control the iPod may be out of date.
Within the first 12 months from date of purchase, subject to the conditions above, will repair or replace the product at their discretion, if it is defective in material or workmanship providing it is returned to an Authorized Neo Car Audio Dealer, with PROOF OF PURCHASE from an authorized dealer.
Need help?
Do you have a question about the TY1 and is the answer not in the manual?
Questions and answers