Related Manuals for Neo Car Audio PODTOYV220
Summary of Contents for Neo Car Audio PODTOYV220
- Page 2 Thank you for purchasing a Neo Car Audio product. This manual describes the functions and operation of the Neo ProLink PODTOYV220 iPod interface for Toyota and Lexus cars. Please read this manual before installing the product in your vehicle. !!IMPORTANT!! It is strongly recommended that the unit is installed in an accessible location.
- Page 3 DIRECT MODE, PLAYLIST MODE, and AUX OPTION PODTOYV220 provides two ways to control and access your iPod through the car radio, Direct Mode and Playlist Mode. 2-1 Direct Mode: Search and select music on iPod just as you would in normally. The music will play back through your car stereo.
-
Page 4: Section 3. Cable Connection
2-3 RCA AUX INPUT In addition to the iPod, PODTOYV220 can connect a second audio source to the radio. Connect the second audio source to the RCA jack labeled AUX INPUT. AUX input is enabled by setting the DIP switch #1 (on the side of the interface adapter) to ON position. - Page 5 WARRNING!! Use only the iPod connection cable which comes with the PODTOYV220 interface adapter. iPod connection cables from other sources may look similar, but they may damage your iPod. SECTION 4. APPLICATION & DIP SWITCH SETTINGS Part 1-for RCA AUX Input..
- Page 6 Part 2- for radio recognition... ** 2010 vehicles equipped with USB connectors are not compatible.
- Page 7 Please note.. If PODTOYV220 conflicts with CD changer or can not be recognized by radio, turn ACC (ignition) power ON and OFF 6 times within 15 seconds to complete re-configuration. In 2001 models, the built-in CD changer may not be functional while iPod is connected.
- Page 8 SECTION 5. CONNECTING & PLAYING of iPod After iPod is connected to the Neo ProLink, iPod will take a few moments to get into external control mode. During the initialization, iPod screen will change continuously for approximately 25 seconds. 5-1 When using it with a MP3/WMA compatible navigation radio 5-1-1 Synchronization with radio Press the AUDIO and DISC button on the radio and wait until either Fig.
- Page 9 In Fig (1) screen, function of the touch buttons are assigned as follows:...
- Page 10 On Fig (2) screen, function of the touch buttons are as follows: Note: Radio may only allow this function when vehicle is not moving. 5-1-2 Playback of songs on iPod If iPod was playing a Playlist right before the connecting to the Neo Prolink, the same Playlist will continue to play at DISC 4 on screen Fig ( 1 ) after iPod is synchronized.
- Page 11 Playlist. Playlist Naming (not required for MP3 navigation radio) • When iPod is connected to your radio via PODTOYV220 interface adapter, the adapter scans all available Playlists on the iPod and will automatically assign the first 6 Playlist in alphabetical order. They must be Playlists you created in iTunes.
- Page 12 Playlist is reached, the search will stop at track 1, and then continue by increments of 10 (i, e, 19, 29, 1, 11..). When PODTOYV220 is configured to SAT port press the Fast Forward button. This starts the 10 track jump and requires a second press on the FF button to stop the track jump.
Need help?
Do you have a question about the PODTOYV220 and is the answer not in the manual?
Questions and answers