Specifications; Plug Configurations - Hatco TRH Series Installation And Operating Manual

Plug Configurations

Units are supplied from the factory with an electrical cord and
plug installed. Plugs are supplied according to the applications.
WARNING
ELECTRIC SHOCK HAzARD: Plug unit into a properly
grounded electrical receptacle of correct voltage, size, and
plug configuration. If plug and receptacle do not match,
contact a qualified electrician to determine and install
proper voltage and size electrical receptacle.
NOTE: Specification label located on the back of the unit. See
label for serial number and verification of unit electrical
information.
NEMA 5-30P
NEMA 6-30P
CEE 7/7 Schuko
Plug Configurations
NOTE: Receptacles are not supplied by Hatco, but are
available as accessories.
Form No. TRTKm-0812
Connecting Supply Wires
If local codes require Greenfield or conduit hook-up, consult a
licensed electrical contractor to perform supply wire connection.
access to the unit wiring is through the rear lower access panel.
To connect supply wires to the toaster:
1. Remove the screws securing the side panels, and remove
2. Remove the screws securing the rear lower access panel,
3. Insert the Greenfield or conduit through the opening in the
4. attach the ground wire to the power supply bracket at the
5. Reinstall access panel and side panels.
NEMA 6-20P
BS 1363
5
the side panels.
and remove the panel.
rear access panel and attach to the power supply bracket.
Connect the wires.
threaded hole marked "G".

SPECIFICATIONS