Safety Precautions - Venturer PLV3117i Owner's Manual

Safety PrecautionS

* See ReaR OF UnIt FOR GRaPHIc SymBOlS *
The lightning flash with an arrowhead
within a triangle alerts you to uninsulated
dangerous voltage within the product's
enclosure that could cause an electric
shock.
The exclamation point within a triangle
alerts you to the presence of important
operating, servicing and maintenance
instructions in this user's manual.
InVISIBle laSeR RadIatIOn WHen OPen.
aVOId eXPOSURe tO Beam.
Placement InFORmatIOn
• Do not use this unit in places which are extremely hot, cold, dusty, or humid.
• Do not restrict the air flow of this unit by placing it somewhere with poor air flow, by covering it with a cloth, or by
placing it on bedding or carpeting.
SaFety InFORmatIOn
• When connecting or disconnecting the AC power cord, grip the plug and not the cord itself. Pulling the cord may damage
it and create a hazard.
• When you are not going to use the unit for a long period of time, disconnect the AC power cord.
cOndenSatIOn InFORmatIOn
• When left in a heated room where it is warm and damp, water droplets or condensation may form inside the unit. When
there is condensation inside the unit, the unit may not function normally. Let the unit stand for 1-2 hours before turning
the power on, or gradually heat the room and allow the unit to dry before use.
RatInG Plate lOcatIOn
• The rating plate is on the back of product.
WaRnInG: Should any problems occur, disconnect the AC power cord and refer servicing to a qualified
technician.
Fcc InFORmatIOn
WaRnInG: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user authority to operate the equipment.
nOte: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an AC power outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this unit to ensure compliance with the Class FCC limits.
WaRnInG: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.
WaRnInG: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
DO NOT PLACE OBJECTS FILLED WITH LIQUIDS ON
OR NEAR THIS UNIT.
caUtIOn: USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED MAy RESULT IN HAZARDOUS RADIATION
EXPOSURE.
caUtIOn: DANGER OF EXPLOSION IF BATTERy IS
INCORRECTLy REPLACED. REPLACE ONLy WITH THE
SAME OR EQUIVALENT TyPE.
claSS 1 laSeR PROdUct
the symbol for
class II (double
lnsulation)
E - 2
this product
contains a low
power laser device.