Solarsat Setting; Auto Scanning; Manual Scanning - Samsung DSR 9400T Instructions For Use Manual

OPERATING THE RECEIVER

1.3 Solarsat Setting

This menu is only for the Solarsat antenna.
When you press this menu, you will get this message,
"This menu is only for the Solarsat antenna.
If you have one-press OK, otherwise-press EXIT."
You can set the value according to your location.
To set the Value of Date and Time, use the Pg-/Pg+
keys to change the value.
Use the / keys to change position.
Use the / keys to move each filed.

1.4 Auto Scanning

The sub menu "Auto Scanning" will enable download
the channels automatically from the preprogrammed
satellites.
To download channels automatically:
You can select All/Off/Only Free option mode in each
satellite.
Off : No Scan
All : Scan all the channels
Only Free : Scan free channels
Press key.
Auto Scanning menu will be displayed.
All the channels in the list from the selected satellite will be
automatically downloaded.
After scanning you will see "Your digital receiver found...".
Then, you should press key to store all channels into STB.
GB-18
D I G I T A L S

1.5 Manual Scanning

To tune-in new channels and weak signals,
the STB has been provided with
the option "Manual Scanning" where the channel data
can be entered by the user.
After selecting the "5. Manual Scanning" from the
Installation Menu, the following screen will be displayed:
Select the target satellite for manual search.
Load a transponder.
This option will enable the user to load any
transponder from the preprogrammed list
available within the receiver.
N N o o t t e e : Especially on New tranpsonder at Load TR,
this new transponder can be added into
transponder list so that you can use it on Auto
Scanning later, only if at least one channel is found
with this new transponder. In order to save it, press
Input the frequency of the transponder you want to find.
Input the symbol rate of the transponder you want to find.
Select the FEC(Forward Error Correction)of the transponder
you want to find.
You can select the value of 1/2, 2/3, 3/4, 5/6, 7/8 or Auto.
Select the polarization of the transponder you want to find.
(Horizontal/Vertical/Circular Left/Circular Right)
In the case of horizontal, 18V and in the case of vertical,
13V are output through LNB line.
Select Scan Mode "All" or "Only Free".
Set "Yes" on Network Search. You can get more channels from transponder using
the homing transponder. Additionally, you can get 'Provider Name' on the screen.
Select PID searching "Yes". You can manually search by entering individual
PID(Packet Identifier)(Video/Audio/PCR) values.
After select option, press
A T E L L I T E R E C E I V
OPERATING THE RECEIVER
key.
key to start the scan process.
GB-19
E R