Audiovox Pro9056TW Owner's Manual

Pursuit series single channel remote car starter

Hide thumbs Also See for Pro9056TW:

Single Channel Remote Car Starter

FEATURES :

 1 Programmable RF Transmitter, 1 Programmable RF Transceiver

 Single Channel Receiver (capable of accepting 4 transmitters)

 External Superheterodyne Receiver Antenna w/PushButton Switch &

LED

 On-Board Start Relay

 On-Board Accessory Relay

 On-Board Ignition 1 Relay

 On-Board Ignition 2 Relay

 Ignition 2 Relay Selectable On or Off During Cranking

 On-Board Parking Light Relay

 Ignition 3 / Shock By-Pass / GM VAT Output (relay required)

 Tach Signal Learning Circuit

 Two ( + ) and Two ( - ) Safety Shutdown Circuits

 Alarm By-Pass Output

 Accessory Outputs (Pulse Before & After Start, During Crank & After Shut Down)

 Selectable Steady or Flashing Parking Lights for Run Indication

 Selectable 5, 10, 15, 20, 45, and 60 Minute Run Time

 Car Finder Mode

Optional Door Unlock Feature For Vehicles Equipped With Power Doors

(Only operational while running under control of the remote start unit.)

PATENTED: www.voxxintl.com/company/patents

Rev A: Add new URL 11/4/2011

Rev B: New Format 5/2013

Model Pro9056TW

Owner's Manual

128-8856b

1 of 4

Table of Contents

Need help?

Do you have a question about the Pro9056TW and is the answer not in the manual?

Page 1 Model Pro9056TW Owner’s Manual Single Channel Remote Car Starter FEATURES :  1 Programmable RF Transmitter, 1 Programmable RF Transceiver  Single Channel Receiver (capable of accepting 4 transmitters)  External Superheterodyne Receiver Antenna w/PushButton Switch &  On-Board Start Relay ...
Page 2 REMOTE STARTING THE VEHICLE This will not start the vehicle if any one of the following situations exists: The vehicle's hood lid is opened. The gear shift selector is not in Park. The brake pedal is depressed. The safety control switch is in the Off position. 1.
Page 3 UNLOCKING THE VEHICLE: If you have an electric door lock, and the Optional Unlock feature was added, with the vehicle running under command of the remote start unit, press and hold the transmitter button for 3 seconds until the doors unlock. CAR FINDER MODE: Anytime the vehicle is not running under control of the remote start unit, within operating range of the vehicle, press and hold the push-button of the hand...
Page 4 c. From b, press and release the valet/programming button 1 time to get to channel 7, then press any unused transmitter button or button combination to program. NOTE: Not all systems have channels above 3, check with your installation center for options your system may or may not have.