Table of Contents
Advertisement
Quick Installation
E
1 Connect video cable
N
Make sure both the monitor and computer
G
are powered OFF.
L
Connect the video cable to the computer,
then to the monitor.
S
Macintosh users: Models older than G3
require a Macintosh adapter. Attach the
H
adapter to the computer and plug the video
cable into the adapter.
To order a Macintosh adapter, contact your
reseller.
2 Connect power cord
Connect the power cord from the monitor to
a properly grounded AC outlet.
3 Power-ON monitor and computer
Power-ON the monitor, then power-ON the
computer. This sequence (monitor before
computer) is very important.
NOTE: At this point Windows 98 users may
receive a message asking them to install the
Q110 INF file.
4
AC Outlet
Optiquest
Q110
4 Install INF and ICM files
For CD-ROM: Insert the CD-ROM, select
"Monitor Drivers," and follow the on-screen
instructions.
For diskette: Insert your diskette and run
install.exe. Follow the on-screen
instructions.
5 Windows users: Set the Timing
Mode (resolution and refresh rate)
Example: 1024 X 768 @ 75Hz.
For instructions on changing the resolution
and refresh rate, see the user guide for your
computer's graphics card.
Installation is complete. Enjoy your new
Q110 monitor!
To be best prepared for any future customer
service needs:
Write the serial number (see back of the
monitor) in "For your Records" on page 2 of
this guide.
Register the warranty of your monitor on the
Internet at:
www.optiquest.com
Video Cable
Power Cords
Advertisement
Table of Contents
