Enhanced Use - Philips SACD Player Manual

Enhanced use

Filter switch
Not all amplifiers/receivers and speakers can handle the
extended frequency response of SACD. Your SACD is
equipped with a switchable filter on the rear. The
factory setting of this filter is 40 KHz which is safe for all
systems. If your system can handle the full frequency
range of SACD (check the relevant manuals or, when in
doubt, contact your dealer) do the following:
VOLTAGE SELECTOR
220-240V 100-120V
Set the switch to the required output signal.
Position 1 : 40 kHz - output signal on all speakers is set
to 40 kHz.
Position 2 : 50 kHz FRONT/40 kHz OTHERS - output
signal on front speakers is set to 50 kHz;
output signal on all other speakers is set to
40 kHz.
Position 3 : 50 kHz - output signal on all speakers is set
to 50 kHz.
Warning: When you are not sure your system is
able to handle audio input signals up to 50 KHz
do not change the output signal. You may
damage your speakers or amplifier/receiver.
32 OPERATION
MAINS
RIGHT LEFT
FILTER
1 2 3
GND
DIGITAL AUDIO OUT
Dolby Digital/
DTS/MPEG/PCM
OPT OUT DIG OUT
System grounding
When your system consists of a lot of components,
occasional disturbance problems (like howling noises)
may occur. These problems can be solved by grounding
the system.
1 Unscrew ground connector GND halfway, connect
an earth wire to the connector and tighten the
connector again.
VO LT
AG E SE
LE CT OR
22 0-2
40 V
10 0-1
20 V
2 Connect the earth wire to the ground connector of
the next component in the system.
3 If ground connectors are available on the other
components of your system, ground the other
components in the same way.
M AI N S
FIL TE R
FIL TE R
1 2 3
G N D