Kenwood DDX6039 Installation Manual page 4

Connection
Connection cable (Included in the disc changer)
Connect to the vehicle's parking brake
detection switch harness
using the supplied relay connector.
For the sake of safety, be sure to connect the parking sensor.
Ground wire (Black) - (To car chassis)
C
Battery wire (Yellow)
B
Ignition wire (Red)
A
Ignition key
switch
Car fuse
box
(Main fuse)
+ –
+
Battery
4
|
English
Disc Changer etc.(Optional)
Parking sensor wire (Light Green)
PRK SW
To vehicle's reverse lamp harness
Connect to the terminal that is grounded when either
ACC
To connect the Kenwood navigation system,
A
Depending on what antenna you are using,
B
connect either to the control terminal of the
motor antenna, or to the power terminal for the
Car fuse box
C
To "EXT.AMP.CONT. " terminal of the amplifier
If no connections are made, do not let the cable come out from the tab.
To car light control switch
FUSE ( 15A )
To steering remote
If no connections are made, do not let
the cable come out from the tab.
the telephone rings or during conversation.
consult your navigation manual.
booster amplifier of the film-type antenna.
When using the optional power amplifier,
connect to its power control terminal.
having the external amp control function.
Antenna Cord FM/AM antenna input
TV tuner (Optional)
Reveres sensor wire (Purple/White)
Dimmer control wire (Orange/White)
Steering remote control input
(Light Blue/Yellow)
REMO.CONT
Mute wire (Brown)
Motor antenna control wire
(Blue)
Power control wire
(Blue/White)
External amplifier control wire
(Pink/Black)