AEG ÖKO LAVAMAT 61300 Instruction Book page 28

Operating Instructions
Excessive foaming
during the main wash.
Water is leaking out
from under the wash-
ing machine.
Fabric softener is not
added, compartment
À for fabric softener
is filled with water.
Appliance does not
spin, water in the
drum.
Washing has not been
spun sufficiently, there
is water left in the
drum.
Door cannot be
opened.
The rinse water is
cloudy.
28
Fault
Probably too much washing
powder was used.
The inlet hose connection is
not tight.
The inlet hose has a leak.
The drain pump cover is not
tight.
Washing is caught in the
door.
Suction cap in the fabric sof-
tener compartment is not
correctly fitted or is blocked.
RINSE HOLD selected.
SOAKING program is termi-
nated.
There is a kink in the outlet
hose.
Drain hose is too high.
Drain pump is blocked.
The water drainage system is
blocked.
The program has not yet
been completed.
Probably caused by a wash-
ing powder with a high sili-
cate content.
Possible cause Remedy
It may be necessary to
reduce the amount of
detergent used. Follow the
detergent manufacturer´s
recommendations.
Tighten the inlet hose con-
nection.
Check the inlet hose and if
necessary replace it.
Tighten cover by turning
clockwise.
Stop the program, remove
the washing caught in the
door, start a new program.
Clean the detergent com-
partment, fit the suction cap
on firmly.
Deselect RINSE HOLD.
Pump out water and set the
main wash cycle as desired.
Remove the kink.
Check the installation
instructions.
Switch off the machine and
pull the plug out of the
socket, clean the drain pump.
Clean the blockage.
Wait until ON/OFF indicator
goes out.
This does not affect the
rinse results. If necessary use
liquid detergent.