Firmware; Flow Control / Baud Rate - Polycom EFIR10 Instruction Manual

buttons to change the Device ID. Press E
proper ID in order to save the ID to the non-volatile memory of the unit.
To set the Device ID of the EF1210, press the switches labeled Device ID 4 and
Device ID 1 to the up position. Cycle power in order for the change to take
effect.
To set the Device ID of the EF200 for use with an EF2280 or EF1210, press the
switches labeled Device ID 3 and Device ID 1 to the on position. The switches
labeled Device ID 4, 2, and 0 should be in the off position. Cycle power in order
for the change to take effect.
To set the Device ID of the EF200 for use with an EF400, press the switches
labeled Device ID 4 and Device ID 2 to the on position. The switches labeled
Device ID 3, 1, and 0 should be in the off position. Cycle power in order for the
change to take effect.
You cannot use the EFIR10 to interface with newer EF Devices
such as the EF2241, EF2201, or EF2211. Use the EFIR11 to
interface with those units.
F
IRMWARE
Here is the minimum required firmware for each unit. The latest firmware is
included with Conference Composer and can be upgraded from Conference
Composer:
• EF2280: 1.11 or higher
• EF1210: 1.05 or higher
• EF200: 1.08 or higher
F C
LOW ONTROL
The EFIR10 sends commands at a data rate of 9600 with no flow control. The
baud rate of the EF1210 and EF200 is fixed at 9600 and flow control is
automatic. EF2280's with firmware version 1.21 or earlier is fixed at 9600 and
flow control is automatic. EF2280's with firmware version 2.00 or later can be
set to a baud rate of 38400 and flow control can be set to off, on , or automatic.
NTER
/ B R
AUD ATE
when you have selected the
5